55M4300CCE00 Rev A
3
CALIBRATION
Step #10: “Zero sensor/Side of boom angle” angle sensor calibration
Address selection dip switch:
The angle sensor installed has its own dedicated address. These switches are factory set
prior to dispatch and will not normally require changing. Please refer to the wiring
diagram to see the address dip switch setting for the angle sensor interface.
Angle Sensor Side of Boom:
1)
Use
“
”
or
“
”
to choose “select sensors” and press
“
”
.
2)
Use
“
”
or
“
”
to choose the relevant angle sensor and press the
“
”
.
3)
Use
“
”
or
“
”
to choose “span sensor or side of boom angle” and press
“
”.
4)
Press
“
”
to highlight the value to edit and use
“
”
or
“
”
to edit the location
of the angle sensor (normally integrated into the length sensor (reel)), press the
“
”
to confirm and then
“
”
to exit.
Note, “right” indicates right hand side of boom when viewed from the operator’cab.
23
Summary of Contents for i4300
Page 2: ...55M4300CCE00 Rev A ...
