Raveon RV-M6S, Technical Manual

Page: 19 / 62

M7 GX Technical Manual
19
Raveon Technologies Corp.
6 = Test Points ON
7 = Transmit CW
8 = Transmit 1010101…
AT
TE
Read product temperature
–
Read the internal temperature of
the unit’s circuit board in degrees Celsius.
-40 to +99
-
AT
VB
Read DC input Voltage
– Returns the DC input voltage reading,
in mV (12500 = 12.5VDC input).
None
none
AT
VR
Firmware Version
– Returns firmware version currently loaded
on the module.
Read Only, 3
characters
none
AT
&F
Restore Factory
– Restore the factory default values. This
command will not erase the calibration values. After this
command executes, the modem will still be in the CONFIG mode.
none
BAND
Read the Band
– Reads the frequency band of the radio.
First parameter is the text version (UA, UC, VB, …), second
parameter is the lower limit, and the third parameter is the
upper limit in MHz. Use to read the band that the radio is
tuned to cover.
None -
CONFIG
Display the M6
’s configuration.
0, 1, or 2 -
CHNUM
Read number of channels. This command will return the
number of channels this product has.
6
MIMIC
MIMIC mode. MIMIC X Y X number of seconds to TX if
input is low. Y is number of seconds between transmissions
when the input is high.
None M6 or M6R
MODEL
Read Model number. Read the model number of the unit.
None M6 or M6R
QSIZE
Read the number of queued WMX frames in the WMX queue.
None -
QCLR
Remove all WMX frames from the WMX frame queue.
None -
SHOW
Show/display an overview of the radio’s configuration.
None -
WMX
Read/set the WMX serial port protocol. 0=off, 1= enabled.
0, 1
0
WMXVR
Read the WMX version
None
WMXINFO
Read WMX information. Returns: Aa, bb, ccc, dd where
AA = Number of WMX message buffers in the product’s WMX
queue.
bb = Number of
WMX messaged queued up in the product’s
WMX frame queue.
ccd = Total size of WMX message buffers in bytes.
dd = WMX version implemented in the product.
** indicates values that are calibrated in the factory and are unit-
specific. If the “Radio
Type” is changed, these will need to be re -calibrated.
6.2. Data Modem Mode Related Commands
These commands apply to the operation of the M6 when it is in the data
modem communication mode.
Command Command Description Parameters
Factory
Default
ATBC
Busy Channel Lock Out – Enable/disable the BCL. If enabled,
the modem will not transmit on a radio channel that is busy (has
RF on if). 0-OFF, 1=ON.
Range: 0-1
0
AT
DT
Destination Address to call
– Sets address of the modem to
send data to. Note, this parameter is entered in HEX format.
Each digit may be a 0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,or an F. Range: 0-FFFF 1234