Raven viper, Installation & Operator'S Manual

Page: 87 / 182

8
Machine Panel and Configurations: 79
MACHINE PANEL AND CONFIGURATIONS
TONGUE/HITCH LENGTH
NOTE: The tongue and hitch length settings are only applicable to pull-type implements and carts and will
not be used with self-propelled or tractor profiles.
Tongue or Front Tongue. Enter the distance in inches [centimeters] from the implement hitch to front axle on a
pull-type implement. The tongue distance must be measured parallel with the direction of travel.
NOTE: Only one tongue length measurement will be required for implements with a single “axle.”
For pull-type implements with an offset working section, set the left or right offset in the section
group settings. Refer to the Equipment Setup - Measurements Tab section on page 84 for assistance
with section group offsets.
Rear Tongue. For implements with a second “axle,” Enter the distance in inches [centimeters] between the front
and rear axles. The rear tongue distance must be measured parallel with the direction of travel.
Hitch. The hitch distance should be entered if the implement or cart will be towed between the machine and
another implement during field operations. Enter the distance in inches [centimeters] from the implement rear
axle to the hitch point on the implement or cart. The hitch distance must be measured parallel with the
direction of travel.
MEASUREMENTS TAB
NOTE: Measurements for pull-type implements are entered on the General Information tab. Refer to the
General Information Tab section on page 77 for details on measurements for these implements.
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Touch a Machine Profile button currently assigned to the machine configuration to view the General
Information tab for the selected machine or implement.
NOTE: Use the page navigation at the bottom of the prompt, or swipe across the screen, to access other
information for profiles assigned to the selected machine configuration.
3. Touch the Measurements tab to view the Profile Measurements prompt.
Edit
or
Self-Propelled
Machine Profile
Tractor Machine
Profile
Measurements