Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 58 / 82

C
HAPTER
6
54 Sidekick Pro™ ISO Installation & Operation Manual
4. Select the Tools icon from the soft keys area and select the diagnostics icon at the top of the display to access
the Product Diagnostics screen for the selected product pump.
PUMP STATUS
The current pump mode is displayed for reference during diagnostic tests. When priming or calibrating the
injection pump, verify that this status display reads “Cal/Prime” before priming or calibrating the injection pump.
The following status modes may be displayed on the Product Diagnostics screen:
RUN TIME DATA
The following information is available for the selected pump control channel.
NOTE: The following usage statistics are the last available values recorded during pump operation.
Pressure. The pressure of the injection product monitored at pump outlet port.
FER Value. The FER (flow to encoder ratio) value is a tool used in conjunction with the FER Error Cal to identify the
relative efficiency of the pump. This area displays a value between 0 and 100.
Motor RPM. The current RPM of the injection pump motor is displayed in this area.
Modes Description
Auto (Automatic) This mode allows for the injection pump to run at a target application
rate (oz./ac or L/ha) by compensating for changes in section width and
speed.
Manual This mode allows for the injection pump to be run at a fixed flow rate
(oz./min. or L/min.). The application rate (oz./ac. or L/ha) does not
compensate for section width and speed changes. This mode is
typically used for testing purposes.
Rx This mode allows the system to automatically change the rate of
injected chemical based upon a prescription map loaded on the UT
display.
CAL/PRM Calibrate/
Prime)
This mode allows for chemical to be primed to the outlet of the pump
and to validate pump performance through a 1 oz. [29.6 mL]
calibration test.
Pump Status
Run Time Data