Raven Sidekick Pro ISO, Installation & Operation Manual

Page: 22 / 82

C
HAPTER
3
18 Sidekick Pro™ ISO Installation & Operation Manual
FIGURE 6. Pressure Drop vs. Flow Rate
MOUNT THE SIDEKICK PRO™ ISO PUMP
AND CHEMICAL TANK
Installation and mounting of the Sidekick Pro ISO injection pump and injection module, or chemical tank, will vary
between implements. Use the following sections to help select an appropriate mounting location on the
implement.
MOUNT THE INJECTION MODULE
The Raven Sidekick Pro ISO injection module provides a platform for mounting the chemical supply tank and
Sidekick Pro ISO injection pump in the optimal configuration for pump operation.
NOTE: The Raven Sidekick Pro ISO injection module may be ordered with a 24 gallon chemical supply tank,
50 gallon chemical supply tank, or without a chemical tank to connect the injection system with an
existing tank on the vehicle or purchased separately.
• Mount the injection module platform in an area close to the boom valve manifold. This minimizes the volume
of chemical in the injection line between the pump and point of injection and allows for more accurate control
of the injected chemical.
• Verify that the hand valves and drain are accessible in the selected mounting location.
• Verify that the injection pump is accessible to perform periodic maintenance.
The assembled injection module will measure approximately as follows:
Tank Capacity Width Depth Height
24 Gallon 28.5” [71.12 cm] 12” [30 cm] (17” [43 cm] with plumbing) 42” [106.75 cm]
50 Gallon 37” [94 cm] 18” [45.72 cm] 62” [157.5 cm]
2” Check Valve and 2” Poly
Mixer (P/N 063-0173-737)
3” Check Valve and 3” Mixer
(P/N 063-0173-698)
3” Check Valve and 4” Mixe
(P/N 063-0173-699)
Flow Rate
Gal./min. [L/min.]
Pressure Drop
(PSI [kPa]
1.5” NPT NH3 Mixer (Without Check
Valve (P/N 063-0173-770)