4
Manual No. 016-3001-015 Rev. C
71
Initial Set Up and Navigation
Profiles
Once the initial set up is complete for the machine settings, it is recommended to save a machine profile. The
profile stores many of the settings previously set during the initial set up procedure as well as any
communication port settings, customized section configurations and guidance feature settings.
If the Viper Pro will be used with different machines or application equipment, profiles allow the operator to
quickly re-configure the field computer for the specific application and equipment type.
Note:
Profiles do not store any information contained in the CAN nodes.
Saving Profile Information
1.
Select
Menu
, then
Setup
,
Local
,
Profile
, and
Save Profile
. The Save Profile screen opens.
2.
Using the screen keyboard, enter a name for the profile.
3.
Touch
OK
. A confirmation screen displays.
Note:
Before saving a profile, make sure that all settings are correct.
4.
Touch
OK
. Viper saves the profile information to the system.
Loading a Saved Profile
1.
Select
Menu
, then
Setup
,
Local
,
Profile
, and
Load Profile
. The Select Profile screen displays.
2.
Select a profile from the list.
3.
Touch
OK
. A confirmation screen displays.
4.
Touch
OK
. Viper restarts with the new profile loaded.
Summary of Contents for OmniSeed Viper Pro
