Raven OmniSeed Viper Pro, Calibration & Operation Manual

Page: 69 / 308

4
Manual No. 016-3001-015 Rev. C 57
Initial Set Up and Navigation
Four Wheel Cart Setup
Note:
A four wheel cart has two pivot points at the center of each cart axle.
1.
Enter the length from the cart hitch to the pivot point on the first cart axle. The hitch length must be
measured perpendicular to the cart axle.
2.
Measure the distance from the first pivot point to the rear cart axle.
3.
Measure the distance to the cart control point or hitch.
4.
Touch the Next button and continue to the Drill Setup section on page 57.
Drill Setup
The Drill Setup screen configures the Viper Pro for the specific drill used with the OmniSeed system.
Note:
The pivot point of the drill is located between the implement wheels.
1.
Enter the total width of the drill as specified by the manufacturer.
2.
Measure the distance from the implement hitch to the drill pivot point (center of the implement axle).
3.
Measure the fore/aft offset of the drill pivot point (center of implement axle) to the rear most row of openers.
The fore/aft offset must be measured parallel with the direction of forward travel.