Raven OmniSeed Viper Pro, Calibration & Operation Manual

Page: 135 / 308

5
Manual No. 016-3001-015 Rev. C 123
Using the OmniSeed Viper Pro System
Product Information
Note:
The Product Information screen(s) will not be available if the Product Application option is not
selected during the job setup process. Skip to the Report Notes Information section on page 124
to finish entering report notes.
15.
The Product Information screen allows the operator enter chemical product information such as the
manufacturer, EPA number, and targeted pests as applicable.
The Viper Pro will store any chemical information entered on the field computer. If the operator selects the
product for a future job, the manufacturer and EPA number will be automatically entered on this screen.
Product Mix. Select the product mix option at the top of the Product Information screen to provide additional
ingredient information on the next report information screen.
NH3 Tank Number. For anhydrous ammonia applications, the anhydrous tank number may be entered to
display the tank number on the job report.
Single Color Coverage Map. If desired, the Viper Pro can create a report showing coverage only. A single
color report will not display high and low rate areas on the coverage map (default).
16.
Verify the product information has been entered correctly and touch the Next button to continue entering
report information. If the product mix option is selected, proceed to the Ingredient Information section below,
otherwise, skip to the Report Notes Information section on page 124 to finish entering report information.
Ingredient Information
Note:
The Ingredient Information screen is only displayed if the Product Mix option is selected on the
Product Information screen. Skip to the Report Notes Information section on page 124 to finish
entering report information if product mix is not selected.
17.
Use the Ingredient Information screen(s) to enter the ingredients of a mixed product solution. Enter the
manufacturer, EPA number, target pests, and mixture rate for the mixture as necessary.
The operator may enter up to five ingredients for a mixed product.