5
Manual No. 016-3001-015 Rev. C
97
Using the OmniSeed Viper Pro System
8.
Touch
Next
. If Product Application was selected, the Product Selection screen displays.
CAN nodes are controlled in a sequential manner and each single product node provides one product
control channel. The operator may only enable the number of control channels currently available on the
machine when setting up a new job. It is recommended to select the maximum number of product control
channels available on the machine each time a new job is started to allow the most flexibility during product
application.
For Example:
If product will be applied from a single tank, but the tank contains a mixture of three products, the operator
must enable one control channel to control rate for the mixture.
To only apply products associated with control nodes 4 and 5, the operator must select 5 on the Product
Selection screen during job setup. If only product nodes 1 and 2 in a 5 product CANbus system will be used
during a job, it is still recommended to select 5 products to allow the operator to enable or disable remaining
product nodes during the job as necessary without beginning a new job. This also allows the job to be re-
opened at a later date to apply additional products using other product nodes.
9.
Enter the number of products which will be applied during the job application.
Product Setup
1.
Touch
Next
. The Product #1 Setup screen displays.
2.
Using the screen keyboard, enter a product name in the
Product Name
field.
3.
To apply a prescription map to the job, enable the
VRC
option.
Summary of Contents for OmniSeed Viper Pro
