Raven OMNiDRIVE, Installation And Operation Manual

Page: 177 / 275

Chapter 3
Note: This value must be set on the Radio Link tab on each machine in the
OMNiDRIVE™ system (e.g. the tractor, the controlling combine
1
, and each non-
controlling combine
2
).
7. Power cycle the machine.
TIB Settings
Check that the TIB Settings tab displays the appropriate calibrations for the OMNiDRIVE™
tractor.
Note: Refer to the RS1™ and RS Lite Calibration and Operation Manual (P/N 016-4010-001)
for additional assistance with the RS Lite features and menus and completing the profile
wizard.
1. From the main CommandView page, select the Menu button in the lower, right corner
of the screen.
1
The combine that may assign paths to, and may sync with, the OMNiDRIVE™ tractor. One
controlling combine is required for all OMNiDRIVE™ locations.
2
A combine operating with the OMNiDRIVE™ tractor and controlling combine. A non-
controlling combine may share harvest coverage data to the coverage map during a harvest
job, but cannot sync with or plan routes for the OMNiDRIVE™ tractor.
177