Raven Envizio Pro, Installation & Operation Manual

Page: 45 / 232

CHAPTER
5
Manual No. 016-0171-148 35
Chapter 5
Startup, Initial Setup
and Setup Wizards
Overview
The first time the Envizio Pro or Envizio Pro II field computer is powered up, the field computer will require
some information about the machine and the type of applications, products and additional features connected
to the system. The field computer gathers this information through a setup wizard which will prompt the user to
input the required information to setup the computer for the first time.
Initial Setup
The initial setup wizard will automatically begin when the console is powered up for the first time. This process
should only take a few minutes to complete and is only required during the initial power up sequence.
Note:
If the field computer displays an alert regarding an authorization code after starting the console,
contact a local Raven dealer or the Raven Technical Support Center for assistance. Refer to the
Special Features Registration section on page 127 for instructions on entering the authorization
code.
The initial setup wizard will require the following vehicle information:
•
Desired language and display units for operation.
•
Guidance width (width of boom or implement without fence row nozzles, foam markers, etc.).
•
Antenna offsets (left/right, fore/aft) and height.
•
Whether the field computer will be interfacing with a CAN system, another Raven serial console or none of
these systems.
•
How the boom master switch operation should be monitored by the field computer.
Other Required Wizards
Additional wizards may be required during the initial startup depending upon the settings and selections
entered during this process. Detailed descriptions of those wizards are also available in this chapter.