Raven Envizio Pro, Installation & Operation Manual

Page: 34 / 232

Chapter 3
24 Envizio Pro and Envizio Pro II Installation and Operation Manual
If connected directly to the ‘DGPS’ connector on the main interface cable (P/N 115-0171-746) or chassis
interface cable (P/N 115-0171-926), the field computer may be used to configure the TM-1. Refer to the TM-1
Tilt Module Installation and Operation manual for details and installation diagrams for installing the Tilt Module
with the Envizio Pro or Envizio Pro II field computer.
Note:
See the System Menu section on page 93 for information on setting up the TM-1 using the field
computer.
When routing tilt corrected signal through a SmarTrax controller and back into the Envizio Pro or
Envizio Pro II, the TM-1 will need to be calibrated through the SmarTrax controller rather than the
field computer. See the SmarTrax Quick Start Guide or Operator’s Manual for more details on
setting up and operating the TM-1 with a SmarTrax controller.
SmarTrax™ and SmartSteer™
Envizio Pro and Envizio Pro II field computers are also capable of operating with the optional SmarTrax or
SmartSteer automated steering systems.
GPS signal is routed into the SmarTrax controller and then fed into the field computer via the ‘DGPS’ connector
on the Envizio Pro main interface cable (P/N 115-0171-746) or chassis interface cable (P/N 115-0171-926).
When the SmarTrax or SmartSteer system is engaged, the automated steering system controls the vehicle
steering system, either hydraulically or by mechanically turning the steering wheel, to guide the vehicle along a
guidance path displayed on the field computer Guidance screen. See the
Source section on page 122 to
configure the Envizio Pro or Envizio Pro II to use an optional SmarTrax or SmartSteer system.
Serial Console
FIGURE 11.
Envizio Pro Interface Cable Platform with Serial Control Console