Raven Envizio Pro, Installation & Operation Manual

Page: 198 / 232

Appendix B
188 Envizio Pro and Envizio Pro II Installation and Operation Manual
Flow Meter/Encoder Extension Cable
Before starting this test, disconnect the flow meter cable from the flow meter. Hold the flow meter cable so that
the keyway is pointing in the 12 o’clock position as shown below.
FIGURE 2.
Flow Meter Extension Cable Pin Diagram
Testing the Flow Meter/Encoder Cable
1.
Enter a meter cal of 1 in liquid or direct injection modes, or density of 1 and spreader constant of 0 in
granular mode, on the Calibration Settings screen in the Product Control menu.
2.
Touch the Volume/Area Settings button and note the total volume for each product node connected to the
CANbus.
3.
Turn the boom and master switch On.
4.
With a small jumper wire (or paper clip), short between the 2 o’clock and 6 o’clock sockets with a ‘short-no-
short’ motion. Each time contact is made, the total volume number should increase by increments of 1 or
more.
5.
If the total volume value does not increase, remove the section of cable and repeat the test at the connector
that is the next closest to the node. Replace the defective cable as required.
6.
Verify the pin connection and voltage from the previous chart.
7.
If all of the cables test good, replace the Rate Sensor.
Note:
After testing is complete, re-enter the correct cal values before starting an application.
10 o’clock
Power
2 o’clock
Ground
Keyway
6 o’clock
Signal
5 VDC
5 VDC