Raven Envizio Pro, Installation & Operation Manual

Page: 193 / 232

Manual No. 016-0171-148 183
Calculating the Calibration Values
Granular Applications
Boom Cal
For Gran 1 (single belt) applications, enter the total width of the spread pattern in inches [cm] as boom 1 cal.
For Gran 2 (split belt) or Gran 3 (dual encoder) applications, enter the left side spread pattern as boom 1 cal
and right side spread pattern as boom 2 cal.
Spreader Constant
Note:
The spreader constant should be verified by performing the procedure in Verification of Spreader
Constant section on page 184.
For Gran 2 or Gran 3 applications, gate width is the total of both openings.
Standard Rate display
For Rates displayed in 1 pound increments, the formula to calculate the spreader constant is:
Where SC = the Spreader Constant, L = Length of belt travel in inches per 1 revolution of the encoder, GH =
Gate Height in inches, GW = Gate Width in inches.
For Example:
Given a Length of belt travel of 13 inches, a Gate Height of 7 inches and a Gate Width of 15 inches:
Enter 228 as the Spreader Constant if the field computer is set to display English units.
Metric Rate Display
For Rates displayed in 1 kg increments, the formula to calculate the spreader constant is:
Where SC = the Spreader Constant, L = Length of belt travel in centimeters per 1 revolution of the encoder, GH
= Gate Height in centimeters and GW = Gate Width in centimeters.
For Example:
Given a Length of belt travel of 33 cm, a Gate Height of 18 cm and a Gate Width of 38 cm:
Enter 797 as the Spreader Constant if the field computer is set to display Metric units.
SC
311 040
,
L GH
×
GW
×
----------------------------------
=
311 040
,
13 7
×
15
×
---------------------------
228 =
SC
18 000 000
, ,
L GH
×
GW
×
----------------------------------
=
18 000 000
, ,
33 18
×
38
×
------------------------------
797 =