Raven AutoBoom 9600, Installation Manual, Page: 26 / 79

C
HAPTER
3
20 Fast 9600 - 80’-120’ Booms AutoBoom Installation Manual
INSTALL THE POWERGLIDE WIRING
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on
both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and
wires.
CONNECT THE HARNESS TO THE BOOM FUNCTION CONTROLS
1. On the AutoBoom harness cable (P/N 115-0230-003), locate the Left Solenoid connector and connect it to Port
4A on the AutoBoom valve.
2. Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
FIGURE 9. Machine’s Cylinder Up Wiring
3. Install a boom sense adapter cable (P/N 115-0171-546) between the machine’s left cylinder up coil and the
connector.
4. Connect the boom sense adapter cable Up connector to the Left Up connector on the AutoBoom harness
cable (P/N 115-0230-003).
5. Install a boom sense adapter cable (P/N 115-0171-546) between the machine’s right cylinder up coil and the
connector.
6. Connect the boom sense adapter cable Up connector to the Right Up connector on the AutoBoom harness
cable.
NOTE: The system will now disengage when Up is pressed on the machine’s controller. The system must be
engaged via the AutoBoom controller or field computer screen.
CONNECT THE HARNESS CABLE TO THE CONTROLLER CABLE
1. Route the harness cable (P/N 115-0230-003) toward the machine’s cab.
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.