17.2 How to Replace the Vacuum Pump Oil
The oil in the vacuum pump must be replaced
when you are prompted to do so by the
device
.
You must carefully read and understand this Operating Manual in order to
perform the provided instructions correctly.
1.
Vacuum
pump
2.
Filler cap
3.
Oil filter
4.
Pump oil level
inspection
5.
Oil drain cap
On the bottom of the equipment there is a specific opening in
front of which you can place a container suitable for collecting
the waste oil.
The opening is near the oil drain cap.
Proceed as follows:
1. Disconnect the equipment from the mains.
2. Remove the left side panel.
3. Unscrew and remove the oil filler cap.
4. Loosen the oil drain cap using an hexagonal wrench no. 5.
5. Wait for all the oil to drain from the pump.
Collect the recovered oil and dispose of it according to the
regulations in force.
6. Tighten the oil drain cap until it is well sealed.
7. Unscrew and remove the old oil filter.
8. Tighten the new oil filter until it is well sealed.
9. Insert new oil to the amount required.
| YUCON | 42 | en
| 2024-03-01
Ravaglioli