13.2 Bluetooth
The Bluetooth module built into the controller allows you to connect the charging station to
accessories such as:
•
A/C system efficiency testing kit;
The Bluetooth connection must be configured through the software functions.
Proceed as follows:
1.
Turn on the charging station.
2.
Access the communication configuration functions.
3.
Start the configuration of the Bluetooth communication.
4.
Follow the on-screen instructions.
For further information see the software's Operating Manual.
13.3 USB
The USB connector located on the right side of the charging station allows you to:
•
back up the reports of the services carried out and the entire system;
•
install updates in off-line mode if the workshop does not have a Wi-Fi network with an
Internet connection.
Do not connect devices to the charging station via the USB
connector.
en | 33 | YUCON |
Ravaglioli
| 2024-03-01