EN
Page 46 of 91
INSTRUCTION, USE AND
MAINTENANCE MANUAL
14.2.1 Programs rapid setting and meas-
urements through distance-diameter
caliper arm
The use of the distance-diameter caliper arm allows
the rapid automatic wheel balancing program and the
measures entry. From page “Home”:
- bring into contact the weights fitting gripper with
the inner part of the rim (1 contact only) to select
"STATIC" program (see
Fig. 46
).
Fig. 46
REPEATEDLY BRINGING THE
GAUGE ARM (FIG. 47 REF. 1)
IN CONTACT WITH THE CHUCK
(FIG. 47 REF. 2), THE PROGRAM
WILL CYCLE FROM "STATIC" TO
"STATIC 1" TO "STATIC 2" RETURN-
ING THEN AT THE BEGINNING.
Fig. 47
- bring into contact the weights fitting gripper with
the inner part of the rim (2 contact points) (see Fig.
Fig. 46
) to select “ALU-S” program.
REPEATEDLY BRINGING THE
CALIPER ARM (FIG. 47 REF. 1)
IN CONTACT WITH THE CHUCK
(FIG. 47 REF. 2), THE PROGRAM
WILL CYCLE FROM “ALU-S” TO
“ALU-S1” TO “ALU-S2”, RETURN-
ING THEN AT THE BEGINNING.
WHENEVER THE DISTANCE-DI-
AMETER CALIPER AND/OR THE
EXTERNAL DATA GAUGE (SEE
FIG. 48(IF ANY) IS KEPT IN PO-
SITION FOR A FEW SECONDS
AGAINST THE RIM (UNTIL THE
MACHINE MAKES AN APPRO-
PRIATE SOUND NOTIFICATION),
THE POSITION IS STORED AND
THE VALUES MEASURED IN THE
PRE-ARRANGED FIELDS IN THE
SELECTED WHEEL BALANCING
PROGRAM ARE LOADED.
Fig. 48
Width
automatic
measurement
- After entering all the required measures, you can spin
the wheel by pressing the button
and closing
the protective guard.
G3.150 - GP3.150 - G3.150S - GP3.150S - G3.150WS - GP3.150WS - G3.150WSPLUS - GP3.150WSPLUS - G3.150SA - G3.150WSA
RAVAGLIOLI S.p.A.
1297-M058-00
