INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Page 19 of 91
9.2.4 Fitting of external data gauge (stand-
ard on some models)
1. Unscrew the fastening screws of the equalizer
support (
Fig. 15 ref. 1
), being very careful about
holding the same support.
2. Screw the 3 screws (
Fig. 15 ref. 2
) to the gauge
bracket (
Fig. 15 ref. 3
) and to the equalizer sup-
port (
Fig. 15 ref. 1
).
Lock the gauge arm (
Fig. 2 ref. 4
) to the bracket
(
Fig. 2 ref. 3
) using the 2 appropriate screws
(
Fig. 15 ref. 5
). Lock these screws with the nuts
(
Fig. 15 ref. 6
), so that the chuck and the gauge
arm are levelled out (see
Fig. 16
).
Fig. 15
3. Also make sure the gauge tip (
Fig. 16 ref. 1
) is
positioned at the centre of the chuck.
Fig. 16
3. Fix the monitor (
Fig. 13 ref. 1
) to the support
(
Fig. 13 ref. 2
) with the screws (
Fig. 13 ref. 3
)
and the washers (
Fig. 13 ref. 4
) supplied.
4. Connect the plugs on the power supply sockets and
monitor signal. Connect the wiring of the keyboard.
Fig. 13
5. Fix the guard (
Fig. 14 ref. 1
) to the support
(
Fig. 14 ref. 2
) with the screws (
Fig. 14 ref. 3
)
and the washers (
Fig. 14 ref. 4
) supplied.
6. Reassemble the plate (
Fig. 14 ref. 5
), previously
unscrewed, with the screws (
Fig. 16 ref. 6
), sup-
plied.
Fig. 14
1297-M058-00
G3.150 - GP3.150 - G3.150S - GP3.150S - G3.150WS - GP3.150WS - G3.150WSPLUS - GP3.150WSPLUS - G3.150SA - G3.150WSA
RAVAGLIOLI S.p.A.
