GB
Page 20 of 64
INSTRUCTION, USE AND
MAINTENANCE MANUAL
1
2
3
4
1
2
1. Remove any type of foreign body from the wheel
(
Fig. 27 ref. 3
): pre-existing weights, stones and
mud, and make sure the mandrel (
Fig. 27 ref. 1
)
and the rim centring area are clean before fitting
the wheel on the mandrel.
2. Carefully choose the cone (
Fig. 27 ref. 2
) most suit-
able for the wheel to be balanced. These accessories
must be selected according to the shape of the rim.
Position the wheel (
Fig. 27 ref. 3
), fitting the cone
(
Fig. 27 ref. 2
) on the mandrel (
Fig. 27 ref. 1
): be
careful (otherwise this could seize) until this rests
against the support flange (
Fig. 27 ref. 4
).
3. Fit the wheel with the inner side of the rim towards
the wheel balancer and against the cone.
Fig. 26
Open/close
the pneumatic
mandrel
Brake the wheel
Fig. 27
4. Fit the protection cap (
Fig. 28 ref. 1
) in the bush
(
Fig. 28 ref. 2
) and bring everything against the
wheel.
Lift the control pedal to close the mandrel and then
clamp the wheel.
Some aluminium wheels, with very high centring, must
be fitted with the cone outside the wheel.
5. Clean the mandrel before fitting the wheel.
6. Fit the wheel (
Fig. 29 ref. 3
) with the inside of the
rim towards the wheel balancer, until the wheel is
up against the support flange (
Fig. 29 ref. 2
).
Fig. 28
12.2 Fitting of the wheel (
GP2.124R)
Open the pneumatic mandrel by pressing “key F4”
from the configuration screen play (
Fig. 96
),
or else open by means of the special pedal, see
Fig. 26
.
G2.124R - GP2.124R
RAVAGLIOLI S.p.A.
1297-M010-0_R
