Rauch TWS 85.1, Instruction Manual

Page: 86 / 104

General maintenance and service 9
80
9.6 Replace the level sensor in the hopper
Figure 9.6: Level sensor TWS hopper
[A] Hopper inside
[B] Hopper bottom, left viewed in the direction of travel
[1] Level sensor
[2] Plastic plug
[3] Level sensor plug connector
1. Remove the cable tie.
2. Unscrew the level sensor [1].
3. Remove the plastic plug [2].
4. Pull the level sensor [1] through the hole in the bottom.
5. Install a new level sensor
6. Insert the plastic plug in the hopper hole.
7. Connect the plug connector [3] of the cable.
2
1
A B
2
3