Rauch TWS 85.1, Instruction Manual

Page: 43 / 104

Commissioning
37
6
6.5 Mount the universal drive shaft to the machine (TWS-M only)
Attachment:
1.
Check the attachment position.
 The drive shaft end that is marked with a tractor symbol must point to the
tractor.
2. Remove the spigot protection and grease the gearbox spigot.
6. Secure the suspension chain through the bore holes in the drive shaft guard
of the machine.
Instructions for dismounting:

Dismount the universal drive shaft in reverse order of attachment.

Never use the suspension chain for suspending the drive shaft.

Secure the dismounted drive shaft using a suitable device.
n
CAUTION
Material damages due to unsuitable drive shaft
The machine is delivered with a drive shaft that is designed according
to the device and performance.
The use of incorrectly dimensioned or inadmissible drive shafts, for
instance without guard or suspension chain, may cause personal
injury or lead to damage to the tractor and/or the machine.
 Use universal drive shafts approved by the manufacturer only.
 Follow the directions in the operator’s manual of the universal
drive shaft manufacturer.
3. Press the slider pin.
4. Pull the universal drive shaft
onto the gearbox stub until it
latches in the ring groove.
5. Release the slider pin.
Figure 6.1: Push the universal drive shaft
onto the gearbox stub