Operation QUANTRON-A
4
82
4.10.7 Changing the units of measurement
The units of measurement have been preset at the factory. However, you can
switch from metric to imperial values and vice versa at any time.
1.
Open the
System/Test
menu.
2.
Select the
Unit
s menu.
3.
Press the enter key to switch between
imperial
and
metric
.
All the values in the various menus will be converted.
4.10.8 Service
4.11
Info
Information on the machine control can be obtained from the Info menu.
Menu/value
Conversion factor
Metric to imperial
kg left
1 x 2.2046 lb.-mass (lbs left)
ha left
1 x 2.4710 ac (ac left)
Working width m
1 x 3.2808 ft
Application rate kg/ha
1 x 0.8922 lbs/ac
Mounting height cm
1 x 0.3937 in
Menu/value
Conversion factor
Imperial to metric
lbs left
1 x 0.4536 kg
ac left
1 x 0.4047 ha
Working width ft
1 x 0.3048 m
Application rate lbs/ac
1 x 1.2208 kg/ha
Mounting height in
1 x 2.54 cm
NOTICE
An input code is required for the settings in the
Service
menu. These settings
can only be modified by authorised service personnel.
As a general rule, we recommend that all settings in this menu are carried out
by authorized service personnel.
NOTICE
This menu provides information on the configuration of the machine.
The information list depends on the equipment of the machine.
Summary of Contents for QUANTRON-A
