Intended use and declaration of conformity
1
1
AXISAXIS
1
Intended use and declaration of conformity
1.1
Intended use
The mineral fertiliser spreaders of the AXIS series may only be used in accord-
ance with the stipulations of the present operator’s manual.
The mineral fertiliser spreaders of the AXIS series are constructed in accordance
with their intended use.
They may only be used for the application of dry, granular and crystalline
fertilisers, seeds and slug pellets.
Any use beyond these specifications is considered as contrary to the intended
use. The manufacturer shall not assume any liability for any damages resulting in
this respect. The risk is solely carried by the operator.
The intended use also comprises the compliance with the operating, mainte-
nance and repair conditions prescribed by the manufacturer. Only genuine spare
parts from the manufacturer may be used as replacements.
The mineral fertiliser spreaders of the AXIS series may only be used, maintained
and repaired by people who are familiar with the characteristics of the machine
and who are aware of the risks.
The instructions regarding the operation, service and safe handling of the machine
as described in this manual and declared by the manufacturer in the form of warn-
ing signs and symbols on the machine must be strictly followed during operation.
Moreover, the relevant accident prevention regulations and the other generally
recognised safety, occupational health, and road traffic regulations must be strict-
ly observed when using the machine.
Any unauthorized modifications to the mineral fertiliser spreaders of the AXIS se-
ries are inadmissible. Such modifications will exempt the manufacturer from lia-
bility for any damage resulting therefrom.
In the following chapters, the mineral fertiliser spreader is referred to as "
machine
“.
Foreseeable misuse
With the warning notes and pictorial warnings attached to the mineral fertiliser
spreader of the AXIS series, the manufacturer points out foreseeable misuse.
Observe these warning notes and pictorial warnings in order to avoid using the
mineral fertiliser spreader of the AXIS series in a way that contradicts the inten-
tions of the operator’s manual.
Summary of Contents for AXIS-M 20.2 EMC
