2
Layout and function
Due to the great variety of different ISOBUS-compatible terminals, this chapter is limited to the
functions of the electronic machine control system without indicating a specific ISOBUS terminal.
•
Please observe the instructions for the operation of your ISOBUS terminal in the
corresponding operator's manual.
2.1
Overview of supported machines
Some models are not available in all countries.
•
AXIS H 30.2 EMC, AXIS H 30.2 EMC + W
•
AXIS H 50.2 EMC + W
•
AXIS M 20.2 EMC, AXIS M 20.2 EMC + W
•
AXIS M 30.2 EMC, AXIS M 30.2 EMC + W
•
AXIS-M 50.2 EMC + W
Supported functions
•
Spreading depending on forward speed
•
Electrical drop point setting
•
RPM control
○
AXIS-M 20.2/30.2/50.2 EMC (+W): Drive shaft speed
○
AXIS-H 30.2/50.2 EMC (+W): Spreading disc speed
•
EMC - mass flow control
•
Continuous section control
2.2
Display
The display shows the current status information as well as the selection and input options for the
electronic machine control unit.
The most important information concerning the operation of the machine is displayed in the
operating
screen
.
2. Layout and function
10
5902180-h-gb-
AXIS EMC ISOBUS