Rauch AXENT Series, Operator'S Manual

Page: 67 / 170

Commissioning
61
6
6.6.2 Connecting the pin coupling (variant B)
1. Start the tractor.

The PTO shaft is switched off.

The hydraulic system is switched off.

The pin coupling is open.
2. Drive the tractor up to the machine.
3. Adjust the height of the hydraulic support stand of the machine so that the
towing eye hooks exactly into the tractor's pin coupling.
4. Apply the handbrake of the tractor.
5. Switch the tractor motor off. Remove the ignition key.
6. Close the coupling pin.
Observe the instructions of the tractor manufacturer.
7. Slowly retract the hydraulic support stand of the machine. See Figure 6.8 .
 The connection is secured.
6.6.3 Hitch coupling (variant C)
1. Start the tractor.

The PTO shaft is switched off.

The hydraulic system is switched off.
2. Drive the tractor up to the machine.
3. Adjust the height of the machine's hydraulic support stand so that the hitch
ring hooks exactly into the hitch hook of the tractor.
4. Apply the handbrake of the tractor.
5. Switch the tractor motor off. Remove the ignition key.
6. Close the hold-down device.
Observe the instructions of the tractor manufacturer.

The connection is secured.
n
CAUTION
Material damage to the universal drive shaft with bottom
hitching
When driving, a collision may occur between the universal drive
shaft and the lower link catch of the tractor. The universal drive
shaft can become bent.
 Move the lower link catch to the top position and secure it.
 Make sure there is enough space for the steering angle.