Rauch AXENT Series, Operator'S Manual

Page: 157 / 170

General maintenance and servicing
151
9
9.12.3 Changing a wheel
Prerequisites:

Use a jack that can lift a load of at least 5 tons .

Use a torque wrench to tighten the wheel nuts.
Positioning the jack:

Position the jack so that the support surface cannot slip under any
circumstances (e.g. with a suitable piece of wood or rubber block).
n
WARNING
Danger of accident due to incorrect changing of wheels
Improper changing of a wheel of the large area spreader can result
in serious accidents involving personal injury.
 Change the wheel only on the empty large area spreader
attached to the tractor.
 To change the wheel, the large area spreader must stand
on level and firm ground.

Additionally secure the jack
against slipping.

When changing a wheel on
the right side in the direction
of travel, place the jack on
the right [1] under the axle
mounting.

When changing a wheel on
the left side in the direction of
travel, place the jack on the
left [2] under the axle at the
height of the spring link.
Figure 9.34: Application points of the jack
1 2