Rauch AXENT Series, Operator'S Manual

Page: 151 / 170

General maintenance and servicing
145
9
Implementation:
1.
Undo the hose fitting at the end of the hydraulic hose to be replaced.
2. Drain the oil from the hydraulic hose.
3. Undo the other end of the hydraulic hose.
4. Immediately drain the detached hose end into the oil collecting vessel and
close the connection.
5. Undo the hose fasteners and remove the hydraulic hose.
6. Connect the new hydraulic hose. Tighten the hose fittings.
7. Secure the hydraulic hose in place with the hose fittings.
8. Check the position of the new hydraulic hose.

The hose routing must be identical to that of the old hydraulic hose.

There must be no chafing.

Do not twist the hose or subject it to tension.
 The hydraulic hoses have been successfully replaced.
9.11.3 Checking the oil level
Check the oil level in the storage tank daily.

Read the level on the level
indicator [1].
The oil level is all right if the
oil is between the green and
red mark on the level gauge.
Figure 9.25: Oil level indicator position