Rauch AXENT Series, Operator'S Manual

Page: 106 / 170

Spreading operation 7
100
7.4.5 Setting the drop point
You can determine a certain range for the working width by selecting the type of
spreading disc. The exact setting of the working width and the adjustment to var-
ious fertiliser types is achieved by changing the drop point.
You can set the drop point by means of the upper scale sheet.

Adjusting in the direction of small numbers : The fertiliser is ejected
earlier. This results in spreading patterns for smaller working widths.

Adjusting in the direction of large numbers : The fertiliser is ejected
later and spread further to the outside in the overlap zones. This results in
spreading patterns for larger working widths.
Figure 7.10: Display for drop point
NOTICE
The AXENT 100.1 large area spreader has an electronic setting of the drop
point.
The electronic drop point setting is described in a separate operating manual for
the electronic control. This operating manual is part of the electronic control.