Rauch Axent Isobus, Instruction Manual

Page: 23 / 74

Attachment and installation
17
3
3 Attachment and installation
3.1 Tractor requirements
Before installing the electronic machine control unit, ensure that your tractor
meets the following requirements:

A minimum voltage of 11 V must always be guaranteed, even if multiple
loads are connected simultaneously (e.g. air conditioning system, lights).

The PTO speed can be set to 1000 U/min and has to be complied with.

9-pin socket (ISO 11783) located at the rear of the tractor for connecting the
machine control unit with the ISOBUS.
The power supply of the machine control unit is implemented via the 9-pin IS-
BOUS socket at the rear of the tractor.

The tractor has to provide the speed signal to the ISOBUS.
3.2 Connections, sockets
NOTICE
In tractors without load-switchable gear, the forward speed must be selected us-
ing the correct transmission ratio in a way that it corresponds to a PTO speed of
1000 U/min .
NOTICE
If the tractor is not equipped with a 9-pin socket at the rear, a tractor assembly
set including a 9-pin socket (ISO 11783) be purchased additionally as special
equipment.
NOTICE
Check with your dealer that your tractor is equipped with the required connec-
tions and sockets.

Due to the numerous configurations of tractor/machine/terminal, please
contact your dealer for selection of the correct connection
NOTICE
If the terminal is to be connected to already existing ISOBUS basic equipment,
its compatibility with
the international standard ISO11783 “Tractors and ma-
chinery for agriculture and forestry - Serial control and communications data
network” is to be checked in advance.