Ratoc Systems WLTL19105.1, User Manual, Page: 8 / 24

2. Setup
5
2. Setup
2-1. Before setup
1. Turn off and unplug the PC and all peripherals.
2. Connect one end of the cable connector to the PCI-CardBus/R2 Bridge board, the other
end of connector to the ISA-IRQ routing board.
3. Remove the PC cover. (Refer to the PC's manual.)
4. Select a free PCI expansion slot next to a free ISA expansion slot, then remove the slot
cover.
2-2. Hardware installation
1. Carefully install the PCI-CardBus Bridge board by firmly pressing the adapter into the
PCI expansion slot you have chosen.
2. Install the ISA-IRQ routing board into the ISA expansion slot next to the PCI slot
where PCI slot where PCI-CardBus Bridge board is inserted.
3. Fasten the retaining bracket with the screw from the slot cover.
4. Replace the PC cover and reconnect the power cable and all peripherals.
NOTE NOTE
NOTE NOTE NOTE
l
If only the PCI-CardBus/R2 PCI Bridge board is inserted to the expansion slot without the ISA-IRQ
routing board, 16-bit PC Cards might not be able to be used with the REX-CBS51.