Original instructions
OPERATING YOUR CHAIN SAW
ADDING BAR AND CHAIN LUBRICANT
(See Figure 9)
Use Bar and Chain Lubricant. It is designed for chains and chain oilers, and is formulated to perform over a wide
temperature range with no dilution required.
NOTE: Chain saw comes from the factory with no bar and chain oil added. Level should also be checked after every
20 minutes of use and refilled as needed.
•Remove oil cap.
•
Carefully pour the bar and chain oil into the tank.
•
Wipe off excess oil.
•Check and fill the oil tank when quick view
oil indicator is below the MIN .Line
•
Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or chain.
NOTE: There is form inserted inside the oil reservoir to fitter dirt and debris from the oil pump.
DO NOT remove
the foam.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the oil tank after each
use then run for one minute. When storing the unit for a long period of time (three months or longer) be sure the
chain is lightly lubricated; this will prevent rust on the chain and bar sprocket.
I M P O R T A N T
To preserve natural resources, please recycle or dispose of oil properly. Consult your local waste authority
for information regarding available recycling and/disposal options.
Fig.9
16-English
