24 / 60
80.06.243_iVario Pro L_XL_IM_V01_en-US
5 |
S
etting up
5
S
etting up
CAUTION
Risk of crushing during setup
Fingers, hands and feet may be crushed under the device.
n
Wear suitable protective clothing during setup.
n
Only lift the device via the designated lifting points.
Requirements
n
If you are not setting up the device on plastic feet as standard, observe the
instructions and steps in the Setup options section.
5.1
Minimum distance to the device
NOTE
Minimum distance is not observed
To avoid damage to the device or malfunctions, the device should be set up
with the specified minimum distance from heat sources or open flames.
NOTE
Damage to the wall at the rear of the device
Water or steam may escape from the safety overflow. Remember this
during setup and check the properties of the wall at the rear of the device.
5.1.1 Distance from walls
No minimum distance is required at the rear of the device.
a
The walls at the installation site are built in accordance with the local fire
safety regulations and are resistant to heat sources.
1. Observe a minimum distance from walls to the left.