Rastergraf
General Information 1-23
1.6 Monitor Requirements
Rastergraf graphics boards can be used with a variety of monitors. For
best performance a monitor should have the following features:
•
VGA compatible 5 Wire RGB with separate TTL horizontal and
vertical sync or 3 Wire RGB with sync on green (see note below)
•
Switchable Termination (for monitor loopthrough)
•
Height, pincushion, width, phase, and position controls
•
Autotracking horizontal and vertical synchronization
•
See tables in Section 1.4 (above) for basic timing requirements
Notes
The Eclipse3 software defaults to standard Multiscan 5-wire RGBHV
(VGA compatible) settings. If you require Sync On Green, be sure to
install
SYNC ON GREEN
jumper.
Eclipse3 graphics boards
DO NOT
support interlaced operation.
