Rasonic RS-V18RW, Operating Instructions Manual

Page: 13 / 16

13
English
How to use
NANOE-G
To purify the air
NANOE-G
• nanoe-G starts automatically when the unit is turned
on with OFF/ON .
• Can be activated even when the unit is turned off.
In this condition, the unit will operate as a fan with
AUTO fan speed and fl ap swing.
To deactivate viruses/bacteria on the fi lter
NANOE-G
POWER
• After the unit is turned off, the nanoe-G in- fi lter
deactivation may activate up to 150 minutes.
Turning on the unit cancels this operation.
• To disable this operation in the future, press and
hold
NANOE-G
until a short beep sound is heard. This
will not disable the nanoe-G to purify the air.
• To restore the nanoe-G in- fi lter deactivation, press
and hold
NANOE-G
until a long beep sound is heard.
AIR SWING
To adjust air fl ow direction
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl aps
swings left/right and up/down automatically.
• Do not adjust the fl ap by hand.
Note
POWERFUL/
QUIET
,
NANOE-G
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
POWERFUL/
QUIET
• Cannot be selected at the same time.
Operation conditions
Use this air conditioner under the following
temperature range.
DBT : Dry bulb temperature
WBT : Wet bulb temperature
Temperature (°C)
Indoor Outdoor
DBT WBT DBT WBT
COOL
Max. 32 23 43 26
Min. 16 11 16 11
To set the timer
To turn ON or OFF the unit at a preset time.
TIMER
SET
CANCEL
ON
OFF
1 2 3
CANCEL
3
2 1 3
1
Select ON or OFF
timer Example:
OFF at 22:00
OFF
2
Set the time
2
3
Con fi rm
SET
TIMER
• To cancel ON or OFF timer, press
ON
or
OFF
then press
CANCEL
.
• When ON Timer is set, the unit may start
earlier (up to 15 minutes) before the actual
set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in
the remote control and repeats daily once set.
For clock setting, please refer to Quick guide.
• If timer is cancelled manually or due to power
failure, you can restore the previous setting
(once power is resumed) by pressing
SET
.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and air fl ow
direction.
• This control is not applicable when TIMER is set.
F569785_YS0115-0.indb 13 F569785_YS0115-0.indb 13 1/20/2015 10:43:41 AM 1/20/2015 10:43:41 AM