Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013
4-29
4.2.3
Step 1 – Network Setup
Use Network Setup (see Figure 4-10) to configure network connectivity to the system. If you
logged-in using the default IP address or if you changed the default IP address using the CLI
wizard, you can make adjustments using this step. This step allows you to make the following
changes:
1. Set System Name?
2. Enter a system IP address. This bonds all the installed GE ports. Then, assign individual
IP addresses to each GE port.
3. Enter Net-mask value
4. Enter Default Gateway (GW) address
5. Enter Domain Name Server (DNS) IP address
6. Check the box to activate Jumbo Frames
7. Or Check the box to de-select Jumbo Frames
8. Click on Save Changes for your settings take effect.
4.2.4
Step 2 – System Initialization
Step 2 System Initialization, shown in Figure 4-12 and Figure 4-13, is used to define a system
name and to set the date and time on the system. Once you have entered the system name, you
can click on Finish to save these settings or click on Next to set the date and time.
All IP addresses must be assigned in order for port bonding to operate properly.
If you change the IP address or netmask value you used to log into the controller,
you will have to login again after clicking on Save Changes with your new IP
Address.
