Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013
4-20
change the default value. Here is a sample of the what you will be asked to provide:
Configure NIC1 as dedicated management port [no]:
Enter the IP address for system [192.168.0.1]:
Enter netmask [255.255.255.0]:
Enter MTU [1500 - Jumbo frame disabled]:
Enter NIC1 [ ]:
Enter NIC2 [ ]:
Enter NIC3 [ ]:
Enter default gateway for system []:
Enter DNS address for system []:
9. Once wizard is complete, connect the PixelStor 5000 to your network (RJ45 network
cables not provided). You are now ready to launch the PixelStor web based
management utility to install and configure your
PixelStor 5000
.
4.2
Configure the System
4.2.1
Storage Manager Overview
PixelStor 5000
ships with a comprehensive web based management console, “PixelStor
Storage Manager”. The web based management console enables users to install, configure
and maintain the PixelStor 5000 from an intuitive easy to use web interface. To access the
PixelStor Storage Manager:
1. Login to the
PixelStor 5000
from any laptop or workstation on the same subnet as the
one you assigned to your
PixelStor 5000
in step 8 above. You do this by opening a
browser window and typing in any of the IP addresses you setup on the PixelStor 5000
in the previous section.
The workstation that will be used for system configuration should be on the same
subnet as PixelStor 5000 .
Be sure to add the IP address to your Local Intranet access list in Internet Explorer
otherwise your browser may not generate the correct output..
