AS212RS User Guide
20
Power Cords
The power cord set included in the system meets the requirements for use in the
country where the system was purchased. If this system is to be used in another
country, contact your sales representative to purchase a power cord that is
approved for use in that country.
The power cord must be rated for the product and for the voltage and current
marked on the product’s electrical ratings label. The voltage and current rating of
the cord should be greater than the voltage and current rating marked on the
product. In addition, the cross-sectional area of the wires must be a minimum of
1.00mm
2
or 18AWG, and the length of the cords must be between 1.8m (6 feet) and
3.6m (12 feet). If you have questions about the type of power cord to use, contact
your sales representative.
The following statement applies only to rack-installed products that are GS-Marked:
This equipment is not intended for use at workplaces with visual display units, in
accordance with §2 of the German ordinance for workplaces with visual display units
Summary of Contents for ApplianceStor212RS
