Raritan PX3TS, User Manual

Page: 99 / 842

Chapter 4: Connecting External Equipment (Optional)
75

For iX7
™
, a third party RJ-45 to "DB9 male" adapter/cable is
required for this connection. See
RJ45-to-DB9 Cable
Requirements for Modem Connections (for iX7
™
Only)
(on page
756).
2. Configure the GSM modem as needed. See the supporting GSM
modem help for information on configuring the GSM modem.
3. Configure the GSM modem settings in the PX3TS to specify the
modem's SIM PIN number and the recipient phone number. See
Configuring the Serial Port
(on page 394).
Connecting an Analog Modem
The PX3TS supports remote dial-in communications to access the CLI
through an analog modem. This dial-in feature provides an additional
alternative to access the PX3TS when the LAN access is not available. To
dial in to the PX3TS, the remote computer must have a modem
connected and dial the correct phone number.
Below are the analog modems that the PX3TS supports for sure:

NETCOMM IG6000 Industrial Grade SmartModem

US Robotics 56K modem
The PX3TS may also support other analog modems which Raritan did not
test.
Note that the PX3TS does NOT support dial-out or dial-back operations
via the modem.
To connect an analog modem:
1. Plug a telephone cord into the phone jack of the supported modem.
2. Plug the modem's RS-232 cable into the serial port labeled
CONSOLE / MODEM on the PX3TS.

For iX7
™
, a third party RJ-45 to "DB9 male" adapter/cable is
required for this connection. See
RJ45-to-DB9 Cable
Requirements for Modem Connections (for iX7
™
Only)
(on page
756).
You need to enable the modem dial-in support to take advantage of this
feature, see
Configuring the Serial Port (on page 394).