Raritan PX3TS, User Manual

Page: 807 / 842

Appendix I: Additional PX3TS Information
783

Wireless IPv4 / IPv6 settings:
Commands for wireless IP settings are identical to those for wired
networking. Just replace the variable <ETH> with the word 'wireless'.
The following illustrates a few examples.
To set or
enable Use this command
IPv4
configuration
method
network ipv4 interface WIRELESS
configMethod <mode>
<mode> = dhcp (default) or static
IPv6
configuration
method
network ipv6 interface WIRELESS
configMethod <mode>
<mode> = automatic (default) or static
To verify network settings:
After exiting the above configuration mode and the # prompt re-appears,
type this command to verify all network settings.

show network
The IP address configured may take seconds to take effect.
Device-Specific Settings
A bulk configuration file will NOT contain any device-specific information
like the following list.
For further information, simply open the built-in bulk profile for a
detailed list of 'excluded' settings.

Device name

SNMP system name, contact and location

Part of network settings (IP address, gateway, netmask and so on)

Device logs

Names, states and values of environmental sensors and actuators

TLS certificate

Server monitoring entries

Asset strip names and rack unit names

Outlet names and states