Chapter 8: Using the Command Line Interface
643
Switching On an Actuator
This command syntax turns on one actuator.
#
control actuator <n> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> on
/y
Variables:
<n> is an actuator's ID number.
The ID number is available in the PX3TS web interface or using the
show command in the CLI. It is an integer between 1 and 32.
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:
Type
y
to confirm the operation, OR
Type
n
to abort the operation
Switching Off an Actuator
This command syntax turns off one actuator.
#
control actuator <n> off
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> off
/y
Variables:
<n> is an actuator's ID number.
The ID number is available in the PX3TS web interface or using the
show command in the CLI. It is an integer between 1 and 32.
Summary of Contents for PX3TS
