Raritan PX3TS, User Manual, Page: 660 / 842

Chapter 8: Using the Command Line Interface
636
Multi-Command Syntax
To shorten the configuration time, you can combine various configuration
commands in one command to perform all of them at a time. All
combined commands must belong to the same configuration type, such
as commands prefixed with
network, user modify, sensor externalsensor
and so on.
A multi-command syntax looks like this:
<configuration type> <setting 1> <value 1> <setting 2>
<value 2> <setting 3> <value 3> ...
Example 1 - Combination of IP, Subnet Mask and Gateway Parameters
The following multi-command syntax configures IPv4 address, subnet
mask and gateway for the network connectivity simultaneously.
config:# network ipv4 ipAddress 192.168.84.225 subnetMask 255.255.255.0
gateway 192.168.84.0
Results:

The IP address is set to 192.168.84.225.

The subnet mask is set to 255.255.255.0.

The gateway is set to 192.168.84.0.
Example 2 - Combination of Upper Critical and Upper Warning Settings
The following multi-command syntax simultaneously configures Upper
Critical and Upper Warning thresholds for the RMS current of the 2nd
overcurrent protector.
config:# sensor ocp 2 current upperCritical disable upperWarning 15
Results:

The Upper Critical threshold of the 2nd overcurrent protector's RMS
current is disabled.

The Upper Warning threshold of the 2nd overcurrent protector's
RMS current is set to 15A and enabled at the same time.