Chapter 8: Using the Command Line Interface
488
Authentication Settings
General authentication settings:
This command displays the authentication settings of the PX3TS,
including both LDAP and Radius settings.
#
show authentication
One LDAP server's settings:
To show the configuration of a specific LDAP server, assign the desired
LDAP server with its sequential number in the command. To get detailed
information, add "details" to the end of the command.
#
show authentication ldapServer <server_num>
-- OR --
#
show authentication ldapServer <server_num> details
One Radius server's settings:
To show the configuration of a specific Radius server, assign the desired
Radius server with its sequential number in the command. To get
detailed information, add "details" to the end of the command.
#
show authentication radiusServer <server_num>
-- OR--
#
show authentication radiusServer <server_num> details
Variables:
<server_num> is the sequential number of the specified
authentication server on the LDAP or Radius server list.
Displayed information:
Without specifying any server, PX3TS shows the authentication type
and a list of both LDAP and Radius servers that have been
configured.
When specifying a server, only that server's basic configuration is
displayed, such as IP address and port number.
Summary of Contents for PX3TS
