Raritan PX3TS, User Manual

Page: 294 / 842

Chapter 6: Using the Web Interface
270
5. To configure the ETHERNET interface settings, see
Ethernet
Interface Settings
(on page 272).
6. Click Save.
After enabling either or both Internet protocols:
After enabling IPv4 and/or IPv6, all but not limited to the following
protocols will be compliant with the selected Internet protocol(s):

LDAP

NTP

SMTP

SSH

Telnet

FTP

SSL/TLS

SNMP

SysLog
Note: The PX3TS supports TLS 1.0, 1.1 and 1.2.
Wired Network Settings
On the Network page, click the ETHERNET section to configure IPv4/IPv6
settings.
If the device's cascading mode is set to 'Bridging', the BRIDGE section
appears. Then you must click the BRIDGE section for IPv4/IPv6 settings.
See
Setting the Cascading Mode
(on page 282).
Enable Interface:
Make sure the Ethernet interface is enabled, or all networking through
this interface fails. This setting is available in the ETHERNET section, but
not available in the BRIDGE section.
IPv4 settings:
Field/setting Description
Enable IPv4 Enable or disable the IPv4 protocol.
IP Auto
Configuration Select the method to configure IPv4 settings.

DHCP: Auto-configure IPv4 settings via DHCP
servers.