Raritan PX3TS, User Manual

Page: 186 / 842

Chapter 6: Using the Web Interface
162

A bar showing OCP current levels

OCP status -- open or closed

Associated line pair
The RMS current bars automatically change colors to indicate the
current status if OCP thresholds have been enabled. To configure
thresholds, see
OCPs (on page 209).
Status Bar colors
normal
above upper warning
above upper critical
Note: The "below lower warning" and "below lower critical" states also
show yellow and red colors respectively. However, it is not meaningful to
enable the two thresholds for current levels.
Transfer Switch
On the Transfer Switch page, you can:

View the transfer switch status, and the history of last several
transfers, such as the transfer log.

Change power transfer settings.

Determine the power quality thresholds of voltage and frequency.

Perform manual power transfer or retransfer
Note: Whenever the PX3TS prevents a manual transfer from being
performed, it is disabled across all interfaces, including the front panel
button, web interface and CLI command.
To open the Transfer Switch page, click 'Transfer Switch' in the
Menu
(on
page 146).
Transfer switch-related information shown:

Transfer switch status

Status of Inlet sensors related to the transfer switch

Indicate which one is the 'active' inlet by showing on
either inlet's section
If is not shown on any inlet, neither inlet is powering the
outlets, which is the "off" state.