Chapter 5: Using the PX3TS
85
Manual Transfer When an Alarm is Present
Manual transfer is prevented when the PX3TS enters an alarm state,
such as the Phase Sync alarm. In certain scenarios, you still can force
the PX3TS to perform a manual transfer by holding the Alarm Override
button while pressing the Manual Transfer button. See
Manual Transfer
Scenarios
(on page 84).
Note: The PX3TS indicates an alarm through the Alarm indicator lamps.
See
Alarm Indicator Lamps
(on page 89).
To perform a manual transfer in the alarm state:
1.
Press and hold the Alarm Override button.
2.
Press the Manual Transfer button.
Power is transferred from the active inlet to the other inlet now. You can
verify the power transfer through the Active Inlet indicator lamps. See
Active Inlet Indicator Lamps
Transfer Switch Indicator Lamps
The Inlet Power indicator lamps are located to the left of the Alarm
indicator lamps. On the indicator lamps, I1 refers to Inlet 1, I2 to Inlet 2,
and O to the Output (outlets).
Summary of Contents for PX3TS
