Raritan PX3-3000 series, User Manual

Page: 744 / 875

Appendix G: Old PX3 Character LCD Display
720
Overview of the LCD Display
Different types of information are shown in different sections of the LCD
display. The diagram indicates the sections.
Section Information shown
The selected mode and target, such as INLET 1, OUTLET
1, SENSOR 1, SENSOR 2, and so on.
The following information is displayed:

Readings, data or state of the selected target.

During the firmware upgrade, "FUP" is displayed.
Two types of information may be displayed:

The "ALARM" status of the selected target.

The selected inlet line number if your PX3 is a
3-phase model.
The measurement unit of the displayed data, such as %
or
.
This section indicates:

The Asset Strip mode if an asset strip has been
connected to the PX3.

The device's USB-cascading state - MASTER or
SLAVE. If it is a standalone device, neither MASTER
nor SLAVE is displayed.
Note: During the firmware upgrade, some PX3 models may show b
x
in
the section 1 to indicate the relay or meter board numbered
x
is being
updated.