Raritan PX3-3000 series, User Manual

Page: 260 / 875

Chapter 6: Using the Web Interface
236
SHX Request Maximum Cooling
The PX3 allows you to remotely activate the Schroff SHX 30's maximum
cooling feature. Both LHX 20 and LHX 40 do not support remote
activation of maximum cooling.
The Request Maximum Cooling feature is available only after the PX3
detects SHX 30. For additional information on the SHX 30 maximum
cooling feature, see the SHX 30 documentation.
To perform maximum cooling:

Go to the SHX page, and click Request Maximum Cooling.
Then the SHX 30 enters into emergency cooling mode and runs at its
maximum cooling level of 100% in order to cool the device.
When maximum cooling is requested for an SHX 30, the message
"Maximum cooling requested" is displayed.
To stop maximum cooling:

Click Cancel Maximum Cooling.
Power CIM
After connecting and detecting a Raritan power CIM, the PX3 shows
'Power CIM' in place of 'Feature Port' in the menu. See
Dominion KX II /
III Configuration
(on page 826) or
Dominion KSX II, SX or SX II
Configuration
(on page 831).
Open the Power CIM page by clicking it in the
Menu
(on page 139). This
page shows the CIM's status, including:

Number of the FEATURE port where this CIM is connected

Its device type

Its connection status
For the functionality of this icon on the top-right corner, see
Feature
Port
(on page 219).