Raritan PX3-3000 series, User Manual, Page: 230 / 875

Chapter 6: Using the Web Interface
206
Yellow- or Red-Highlighted Sensors
The PX3 highlights those sensors that enter the abnormal state with a
yellow or red color. Note that numeric sensors can change colors only
after you have enabled their thresholds.
Tip: When an actuator is turned ON, it is also highlighted in red for
drawing attention.
For concepts of thresholds, deassertion hysteresis and assertion timeout,
see
Sensor Threshold Settings
(on page 793).
In the following table, "R" represents any numeric sensor's reading. The
symbol <= means "smaller than" or "equal to."
Sensor status Color States shown in
the interface Description
unavailable Sensor state or readings cannot be detected. Unknown
unmanaged Sensors are not being managed. See Managed vs
Unmanaged Sensors/Actuators (on page 207).
Normal normal

Numeric or state sensors are within the normal range.
-- OR --

No thresholds have been enabled for numeric sensors.
above upper
warning Upper Warning threshold < "R" <= Upper Critical
threshold Warning
below lower
warning Lower Critical threshold <= "R" < Lower Warning
threshold
above upper
critical Upper Critical threshold < "R" Critical
below lower
critical "R" < Lower Critical threshold