Raritan PX3-1000 series, User Manual

Page: 552 / 744

Chapter 8: Using the Command Line Interface
530
Restarting the PDU
This command restarts the PX3 device. It is not a factory default reset.
To restart the PX3 device:
1. Ensure you have entered administrator mode and the # prompt is
displayed.
2. Type either of the following commands to restart the PX3 device.
# reset unit
-- OR --
# reset unit /y
3. If you entered the command without "
/y
" in Step 2, a message
appears prompting you to confirm the operation. Type y to confirm
the reset.
4. Wait until the Username prompt appears, indicating the reset is
complete.
Note: If you are performing this command over a USB connection,
re-connect the USB cable after the reset is completed, or the CLI
communications are lost.
Resetting Active Energy Readings
You can reset either one active energy sensor or all active energy
sensors at a time to restart the energy accumulation process.
Only users with the "Admin" role assigned can reset active energy
readings.
To reset all active energy readings of the PX3:
# reset activeEnergy pdu
-- OR --
# reset activeEnergy pdu /y
To reset one inlet's active energy readings:
# reset activeEnergy inlet <n>
-- OR --
# reset activeEnergy inlet <n> /y
To reset one outlet's active energy readings:
# reset activeEnergy outlet <outlet_n>